It's very simple !!!!!!!!!!!!!!!!!!!

remove ecu with car


1. you find position flash and remove gum don't take out flash.
2. add suply 

gnd 2,3 pin
+12V (15) 24pin
+12V (30) 32 pin




43pin LAMP MIL (masa), second terminal +12V - connect 12/5W  probe lamp 




Your  probe lamp must be blinking - sygnalise immo


IMPORTANT IT'S 100000% working

first cut immo wire to ecu.use the light on dash (engine mngt not red led)for blinking ref.



one side of the flash is A side the other b side (lets say)

you have 9 pins either side,so 9 on A and 9 on B, short 1A with 1B then 2A with 2B all the way till 9A and 9B.holding each for at least 2 secs, engine mngt light should go out,car will then start.



note:you may have to do it more than once before light goes out but believe me it WORKS.




     1    B   9
     ---------
     | flash  |
   B |        |B
     ---------
     1    A  9

If your mngt lamp stops blinkig - ecu erase memory tms OK


cut 37 pin and mount ecu in car - your car now has no immo