Delete immo Peugeot 206 with Magnetti Marelli, IAW 1AP.80 .

1- Disconnect and Open ECU.

2- Disolder eeprom flash 28f512.

3- Solder a support PLCC 32 pins.

4- Write on a new eeprom the file that is in this
   folder and put the eeprom temporarely in this ECU.

5- Put back ECU in the car and turn ignition on for a 30 seconds

6- Substitute the new eeprom with the original eeprom again.

7- In order for the car not to block immo identify the pin 48 and cut the path.

8- By doing the following steps the ECU will be totally unblocked.

If you have problem after this operation cut the wire on ECU pin 48 (immobilzer).